Finishing support for aerospace and defence supply chains.
We’re now taking enquiries from aerospace and defence suppliers for component, plastic and metal part finishing. Send us your drawings and coating specification, and we’ll tell you honestly what we can deliver.
Capability sheetSY–A&D
- 01
- Specification-ledBuilt around the coating system, colour and finish you specify.
- 02
- Trimite approved applicatorsExperienced with Trimite industrial coatings.
- 03
- Careful preparationCleaning, priming and precise masking on every part.
- 04
- Prototype to batchOne-off parts through to repeat batches.
Your specification, followed carefully.
Supply-chain work lives or dies on detail. We start from your drawing and coating specification, plan the preparation and masking, and agree the finish before any part goes in the booth.
- 01
Specification-led
We work to the coating system, colour reference, gloss level and finish set out in your specification, and ask when something isn’t clear.
- 02
Trimite approved applicators
We’re Trimite approved applicators, experienced in applying Trimite industrial coatings.
- 03
Preparation & masking
Parts are cleaned, prepared and primed, with precise masking on threads, bores, contact faces and anything else that must stay clean.
- 04
Prototype to batch
From a single prototype or first-article part through to repeat batches, laid out and sprayed so every piece matches.
What to send us.
The more we know up front, the faster and more accurately we can tell you whether we’re the right fit.
- Drawings (PDF, or the format you usually issue) and part numbers
- Coating specification: system, primer, colour reference, gloss level and any film-thickness requirement
- Masking: threads, bores, faces and areas that must stay uncoated
- Quantities: prototype, first batch and expected repeat volumes
- Timescales and how parts will reach us
- Any approvals or paperwork your project requires, so we can confirm at the start whether we can meet them
We’ll always be straight with you about what we can and can’t deliver against your specification.
Send us your drawings and spec.
Tell us about the parts, the coating specification and the quantities, and we’ll come back to you with an honest answer and a quote.